Pre-2005 V6 Mustang [Archive] - Page 162 - Mustang Evolution

Pre-2005 V6 Mustang


  1. need to talk to you RGR
  2. Darn intake bolts are impossible to find!
  3. filter size for sc'd cars?
  4. well hell, i'll make a post about it
  5. Transmission Question: 1997 V6 Automatic Transmission ??
  6. what would this combo make? (HP?)
  7. Eval in his FIRST race with a TURBO Eclipse..outcome..!?!?!?
  8. A Ker-Azy question about exhaust notes.
  9. Drag Launch Springs
  10. Transmission Conversion?
  11. My first race with nitrous....
  12. FMS 4.10 Gears
  13. The Correct Computer Chip
  14. sway bars part2
  15. Question about the new CryO2 Mod...
  16. Which one.....????
  17. Just ordered a nitrous setup
  18. WOW, Take a look at this on Ebay?
  19. Computers In Our Stangs...
  20. bolt size on upper intake
  21. Side exhaust,ever seen this?
  22. Ebay Short Shifter
  23. Sway bars
  24. lamer on the freeway
  25. OD feature
  26. Roots blower v2.0 *UPDATE*
  27. Automatic replacement handles
  28. EGR flow insufficent (repost of thread in ECU)
  29. EGR flow insufficent
  30. Is this a good buy?
  31. Nitrous Jet Sizes
  32. Nitrous Installation How-To
  33. ME vs a Car with Rocket boosters
  34. Help after dyno run
  35. Procharger vs. Vortech
  36. Venom Kit for 3.8... December 1st - Anyone buying?
  37. typical ricer
  38. that phenolic is some hard stuff!
  39. UPDATE!! BUTT DYNO SHOWS HP GAINS and is accurate
  40. Suspension upgrade...
  41. Transmission Stuff
  42. Check out these prices for 8.8 rear ends in NYC/NJ.
  43. Swaybar hardware
  44. 96 GT alternator
  45. MIL sensors, and cats.
  46. $150 for a 1990 gt rear, good buy?
  47. Mass air upgrade:
  48. Monkey and V6stanger... check this out plz
  49. Convertible top replacement
  50. New 7.5 3.73 gears for $149.99 with a lifetime warranty
  51. Ordering a Aluminum Driveshaft.
  52. How to on stereo install
  53. Realistic Expectations
  54. 3.8 displacement
  55. what "exactly" do you need to do a body drop?
  56. Reinhart Automotive Chips
  57. nitrous fuel solenoid installation
  58. good place to get 3.73 gears and T-loc for my 7.5
  59. service engine soon light
  60. Rear wheel Posi??
  61. UPDATE!!!Got my O/R H pipe installed today.
  62. Me vs. Mercedes (Probably 92-95)
  63. Need some advice on some realistic numbers from enginebasics
  64. Hypertech Power Programer
  65. need feedbacks due to inconsistent answers..C spring cutting
  66. speedcal?
  67. tranny cooler??
  68. first bolt ons?
  69. Clutch sticking to Pressure Plate???
  70. Procharger???