- Need help making a decision
- X-pipe issues
- do i need an aftermarket MAF?
- x-pipe or h-pipe
- With or Without Air Injection
- revs up quick, revs down slow....flywheel?
- Anyone have Mac LT headers on a V6?
- some advise please
- gears 8.8 or 7.5
- power adders and smog legal
- Upper intake thningies, help
- max camber w/ even tire wear?
- shifting problema
- Ok made up my mind... going to swap for a manual and need input
- Looking at transmissions and had a question
- Any tips and Such for 1st time Run on Track
- 2005 mustang V6 VS V8
- weak braking
- Problem..
- wheel hits my rear fender/quarter panel any help?
- 98 Cobra H-pipe
- 3.73 gears and i what i need
- Vortech for 97 v6
- I Need to know the quarter mile time of my opponet
- turbo or supercharger
- NEW HERE Help on Mac offroad h-pipe
- Gears for automatics
- Side exhuast
- RPM Outlet. Is It Any Good?
- Ported and Polished lower and upper intakes
- 3.8 vs 3.9
- no track where i live need 1/4 mile time help
- pinging with my chip
- owned a ricer
- RPM drop
- How stout is the stock block?
- wth....shop wants 1k for installs
- Will this work on my car?
- vibration coming from the back
- ALT charge
- Direct Bolt on or True dual?
- estimated quarter mile time
- 2000 V6 Auto Tranny Help
- Drag Strips in my area??
- spring isolators neccesary?
- cai
- Half Shafting???
- reset ecu: how?
- IAT inside intake pipe, still check engine light
- roller rockers
- v6 white guages
- gah! CAI check engine light
- rubber grommet too small for IAT...
- CAI...breather tube wont reach pipe
- when unhooking battery....
- installing CAI w/o disconnect battery?
- Punch a hole in my oil pan for my vortech
- So I suck @ teh 5spd...
- how much gain from sct flasher?
- type of gas
- Low power
- got my tri-ax installed
- MAF Question
- odd whistle in 3rd from engine @ WOT
- install kit necessary for gears?
- Sponsorships????
- what chip should i use
- Exhaust help!!!
- port & polish, along with other power adders.
- 1.6" drop, no c/c plates