Well I finally dug the P&P intakes and gasket set from under a pile of junk in my garage. Had every intention of installing this weekend ,till I remembered the upper had been ported for a 70mm TB
I don't think the gasket will seals properly with a stock throttle body, But I could be wrong
I can order a 65mm from BBK and run the risk of getting my balls cut off (Wife got a look at my credit card statement) or just install the lower p&p and put the stock upper on till I can slip the 65 mm passed her prying eyes ??also will I need to get a new M.A.F. HELP
Mods-K&N CAI , True Dual Flowmaster 40, BBK Ceramic Shorties, 3.73 , 25% UDP, 3/8 Phenolic Intake Spacer ,Steeda Tri-ax, SCT Chip/Dyno Tune
"Some people are like Slinkies; useless, but fun to push down the stairs."