Ok yall I know I haven't posted in awhile but I am putting my mustang back together (89 gt hatchback 5.0). Well I just put the bell housing back on and put the tranny up but the arm that pushes the bearing against the pressure plate is really like loose, like it has a lot of play to it. When I disassembled the bell housing and removed the clutch cable from that arm the arm was really tight. As far as I know all the parts are on everything and I have no extras. Should I take it apart again to see if something came undone or will it tighten up after I start it and get it running or does that drive shaft have to be hooked up or something. I don't know what to do. All I know is I don't want to have to drop that tranny again because it was a pain putting it in in the first place. Oiy.