Electric water pump clearance
Ok so I haven't had a lot of luck here with previous posts, not sure if y'all are just tired of me asking questions or what but I'll try again!!
I finally have the motor in radiator mounted and fans connected but when I went to hook up the lower radiator hose the inlet for the electric water pump is too close to the harmonic balancer so when I put the rubber hose on it touches the balancer. Has anyone run into this and if so what was your solution???
Also still trying to figure out what to get rid of/block off as far as heat goes and I got rid of the smog pump and need to know what all to block off or get rid of as far as that goes
Again I am sorry if I annoy anyone with my questions but this is my first build and I am doing it all by myself, a Haynes manual and the internet so please be patient with me...thanks