Well I cried a little today. :cry
but i cheered up when i realized it will help me.
got pass side 90% done. need to take the grinder back over it and smooth it out and trim a little more up near the top.
first time using this
had to have some good music though while doing it
here is where i started crying cause i was losing good sheetmetal
first cuts made...got easier after the first couple slices a made
in the middle
the trimmed pieces
decided to start attacking my fender mounts to get ready to mount the sliders too. gotta finish working on this one too
decided not to do a full cut of the fenders because as of right now i have plenty of up and down travel. i can always trim more if needed but it is suffiecent for now, becaue the areas that hit with the slightest flex are gone, at least on pass side.
tomorrow i will do the drivers side and finish with the fender mount tabs. then start prepping for paint...got 8 of the rattle cans i need so far, need to check wally world to see if they have anymore.