My setup for a carputer in my 2000 mustang
was as follows: remove the CD player from the bottom DIN slot, lower the radio to that DIN slot and install a flip out monitor in the DIN where the radio came from. After completing the installation of the flip out monitor, I tested all my electronics and realized that all had gone flawlessly, except for the speaker volume. The volume has to be raised nearly all the way to even hear a peep.
I reattahed my CD-player a few moments later, and the speaker volume does return to normal volume levels. However, since there are no further available DIN slots for the Cd-player in the bezel, what should I do to correct the volume problem? Also, is this stock Cd-player required to be attached with the stock radio for normal volume functionality?
Thank you all in advance for your replies. Also, I am extremely excited about posting pics of my stang. I only hope I have done justice to my beast. : )