So after having only had my deck and and back up camera in my car and then pulling it when I thought I was going to sell the car I decided to put everything back in and more and take a few pics!
First step was get it in the shop and pull it apart
I pulled the bat and the bat tray to get to the big grommet under the passenger dash. (1/0 ga is already in)
Had to drop the wheel liner to get to the grommet.
And the power wire in the car.
Have to use the big cutters for this stuff
Bat is back in and power wire is hooked up. Still might go with a aftermarket bat connecter. Not sure I like how it's hooked up.
To get the deck in undo the 2 screws under the center consul.
Pull the center out (just a few clips)
Next is the two knee panels on booth sides of the dash/radio
Next I unplug the heater controls.
Unscrew and pull aside the dash (I never unplug the passenger airbag light)
Then I pull the radio
Then I tap my reverse light for my back up cam
Then I make my harness connections and pop the radio into the dash kit and plug every thing in and make sure it works.
Don't have a lot of pictures of the rest of this but this is my amp in
My system bumped for about a hour before my amp failed but I bought the protection plan so I'll be getting it swapped this tus. At some point too when I have some $$$ I'll be putting my 4 Chanel amp back in and replacing all of my speakers.