Mustang Evolution Forum banner

removing airbags and seat belts... how to prevent dash lights and etc?

3K views 5 replies 5 participants last post by  51008 
#1 ·
Airbags and seat belts are coming out, how do I defeat a dash light or a tone for both the seat belts and the air bags? I know on earlier models you can use a resistor for the steering wheel air bag. How do I take care of everything?
 
#3 ·
There a step by step for deactivating the seat belt chime, I have mine disabled, look it up, but all you do is basically plug in and unplug your belt 10 times
 
#5 ·
I installed a Braum driver's side race seat and did the 2ohm resistor bypass. After starting my 2011 GT, the dash light goes out for about 5 seconds, then comes back on? I soldered the resister in and wonder if the heat from the soldering iron fried the resistor. What am I doing wrong?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top