Originally Posted by Terminator
So my new FRPP cams are going in on Monday pretty stoked question is what is the proper way of breaking them in? Should I do an oil change ? Thinking of switching to RP while I'm at it
Those cams should come with instructions for breaking them in.
I'm not familiar with the mod cams break-in procedure but if its anything like the pushrod engines, when you start the engine, after install, you IMMEDIATELY run it up to about 1500RPM and hold it there for about 20 minutes. If I recall correctly.
Like I said, they should come with break-in instructions.
After this initial run-in, they are ready to go...
JUST POUND ON THAT BEEEOTCH!!!!!!!