I am trying to replace my stock rear rotors with a new set of SSBC slotted and drilled rotors. the only issue i am running into is, simply the rotor will not break loose. i have the caliper and the anchor plate removed. is there anything i am missing?
use some Kroil/WD40/Penetrate. Let it soak near the hub and studs. Then get a rubber mallot or something softer than the rotor(if you don't want to damage it - if you don't care then use a 5lb mall) and hit the inside of the rotor, pushing it off, do this in a circle or different spots until it comes loose.
Make sure there are no metal retainers on the studs either!