Re: Help, rear axle bearing is bad
It's not too bad. Pull the wheels, then brakes. Pull the diff cover, then pull the center pin out of the t-lock(held in by one 8mm bolt), then push the axles in and remove the c-clips, then remove the axles, pull the old seals and bearings, put the new ones in and reverse the procedure. You will need a slide hammer to remove the old bearings.
2000 Vert, 4.6 SOHC swap, old set-up intercooled s-trim @11lbs..New setup-5.0 stroker, stage 2 heads, kenne bell 2.2l with a 2.75"