Cobra brakes

[02PONY]

Any of u guys swap out your brake system for the 03/04 cobra brakes/rotors/spindles etc
If so what kinda improvements did u see and was it worth the money

[wolfstang03]

I did the rotors and calipers. Direct replacement. No need to do spindles and whatnot. Awesome improvement along with steel braided lines.

[DaBluedude]

Went from the standard gt brakes to the cobra brakes in my mach 1 and they are a huge difference. Initial bite is way better and the fade takes longer and it dissipates quicker. Get a drilled and slotted set if rotors and be careful not to step on the brakes while fully stopped. That's what causes warping more than anything. Someday I would like to upgrade to a full floating baer 6 piston front brakes and ill try custom fit the cobra brakes to the rear. Should get 60-0 down to 100ft.

[wolfstang03]

Originally Posted by DaBluedude

Went from the standard gt brakes to the cobra brakes in my mach 1 and they are a huge difference. Initial bite is way better and the fade takes longer and it dissipates quicker. Get a drilled and slotted set if rotors and be careful not to step on the brakes while fully stopped. That's what causes warping more than anything. Someday I would like to upgrade to a full floating baer 6 piston front brakes and ill try custom fit the cobra brakes to the rear. Should get 60-0 down to 100ft.

What mach1 do you have? The bullitt, cobra, and Mach brakes are all the same, just different logos on them ..

[sonicpony03]

Originally Posted by wolfstang03

What mach1 do you have? The bullitt, cobra, and Mach brakes are all the same, just different logos on them ..

+1 the 03/04 mach 1's came with the same aluminum dual piston calipers and brembo 13" rotors.

As said the logos are the only difference..."cobra" on the 99/01 and 03/04's and the white running pony on the bullitts.

The mach's didn't have any logos, just the anodized finish.

Or did you get the big brembos from the 00 Cobra R?

[DaBluedude]

Originally Posted by wolfstang03

What mach1 do you have? The bullitt, cobra, and Mach brakes are all the same, just different logos on them ..

I know. Its an 03 with the twin piston brakes. I've actually seen mach1s that came with the cobra stamped calipers. Some of the 04 machs got them because of a surplus.

[2002VertGT]

I found cobra calipers for $35 each and rotors for $40 each...just gotta get the $...not telling where either

[onesickstang01]

Calipers are the cheap part. Try fining the brackets lol

[2002VertGT]

Originally Posted by onesickstang01

Calipers are the cheap part. Try fining the brackets lol

The brackets are with these calipers..

[onesickstang01]

You are good then!

[DaBluedude]

The sve guys make the brackets now too. Think they were listed at 40 a side 65 for both. I remember when guys were asking 240$ for them...

[Cobra Morales]

hey guys i dont know how to a post for some reason. so iam trying to replace the whole calipers on my mustang cobra 1997 what kinda of calipers and brackets should i use please help. dont want me and my kids to crash tyhanks