Re: Need instructions on how to replace seatbelts
Here's something I found that might help ya
Remove the back seat. The bottom is held in by a push button latch about 10 inches in from each side. Use a flat blade screw driver to push in the button. Remove the bottom. The back is held in with 2 18mm nuts. Remove nuts,pull out and up to remove seat back.
On the panel,remove the top speaker cover,it is held in with clips. remove the T bar between the speaker cover and seat belt. The side panel is held in the rear by 2 plastic studs that are where the seat back rests,and 1 platic stud on the top edge. The front is held in with 2 little trim studs that are in the weather strip. After these are removed,pull the panel towards the front. It has 2 metal clips holding it to the body.
Once it is off the seat belt is right there
Mods-K&N CAI , True Dual Flowmaster 40, BBK Ceramic Shorties, 3.73 , 25% UDP, 3/8 Phenolic Intake Spacer ,Steeda Tri-ax, SCT Chip/Dyno Tune
"Some people are like Slinkies; useless, but fun to push down the stairs."