Mustang Evolution Forum banner

2012 GT500 exhaust on 2013 v6

1K views 9 replies 5 participants last post by  lllTRADEMARKlll 
#1 ·
Muffler shop did it in an hour. Very mild sound...until you get on it. Then it sounds awesome. Nice idle rumble.

Only thing that needed to be done was to cut the inlet pipes off, expand the v6 pipe to fit and weld it on.

Paid 219 on fleabay and 80 to install.

Good value for a decent exhaust. Saved almost 400 bucks over a louder one that would yield only decibels...although it does seem faster...lol
 
#2 ·
I've been saying this all along. Paid under 200 for mine, and 89 bucks for the welding as well. Now we both ended up with some extra cash for other mods!
 
#9 ·
Sounds good. I was looking for a set a while back and while searching found a brand new set Flowmaster Force ll for 280 shipped which was a steal imo so I grabbed those but I would get these especially if you wanted to do other exhaust mods like headers or an offroad pipe set. These sound nice without the added volume.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top