I have seen posts of older model mustangs with amplifiers screwed into the rear seats. I would like to do the same thing to mine, but don't know what hardware to go with or how to go about doing it.
What material is behind the carpeting for the rear seats? It feels like plastic but i can't really tell.
Can i use self tapping wood screws for it? Pilot hole first? (I'm not very educated with power tools at all)
Also, are there any wires that i could accidentally drill through. (I assume there are no airbag sensors since they would be on the bottom of the seat)
On a side note, what size torx bit is the bolt shown in the picture (the silver one)? I will be using it for a ground but don't want to buy a whole set of bits to take out one bolt.
(Image taken from JDwalton on Mustangforums.com)
Any help or knowledge would be much appreciated.