Originally Posted by JohnnyBob
Not was I was asking but answered the question still. I have the Roush diffuser and I am looking to switch over to the Boss diffuser (going back to round tips) due to me selling the stang. That way I can install the stock exhaust mufflers.
Essentially what I'm trying to ask is if the cutouts (when I say cut outs I mean what I had to drill and saw to fit the tabs) to fit the Roush diffuser the same as the Boss diffuser that way I can just plug-and-play?
Sent from my iPhone using Mustang Evolution
That is the piece that I had to cut off to install the Boss302 diffuser. I'm guessing it's the same exact setup for the Roush because there are pre-drawn lines to cut as well as four tabs (2 on each side) to cut out. Hope this helps
Procharged D1 on 12Lbs, MPT 93 Tune, 73mm BBK TB, Ported Upper/Lower Intakes, BBK Shorty Headers, FRPP Cut n Clamp Xpipe, Borla S-Types, Barton Short Shifter/Blowfish Bracket, SS Clutch Line, Whiteline Trans Bushing, One Piece Driveshaft, Front and Rear Tower Brace, Whiteline Front and Rear Sway Bars, Whiteline Adj LCAs/Adj UCA, BMR Relocation Brackets, BMR adj Panhard Bar, Eibach Sportlines, FRPP Dampers, 20" AMRs, 3.55 gears, Brembos