Mustang Evolution Forum banner

First design of custom rear diffuser. Opinions?

2K views 4 replies 5 participants last post by  primer2tone 
#1 ·
Motor vehicle Automotive design Car Drawing Automotive exterior


After i finalize the design we are going to make a
Mold of the rear valence and use canards as the base for air splitters And fiberglass over them. Finished product should be a one off diffuser limited to the LM mustang. Opinions?
 
See less See more
1
#3 ·
Yellow50 said:
After i finalize the design we are going to make a
Mold of the rear valence and use canards as the base for air splitters And fiberglass over them. Finished product should be a one off diffuser limited to the LM mustang. Opinions?
Its cool, but its almost exactly like the '13 GT/CS rear diffuser.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top