I want to thank LEXiiON, ebalderas and 5.0verkill.
Below are my findings in my quest to build a harness. So I hope this helps others make there own harnesses. all parts were purchased on eBay. except for wrap solder shrink wrap harbor freight.
Pin 1 Low beam
Pin 3 DRL Power Full
Pin 5 DRL Power Dim
Pin 8 Ballast Ground
Pin 10 Power Ballast
Pin 12 Power High beam
Pin 14 Ground
Using Motocraft WPT 1357
I wired pins 1 and 10 together for power and pin 8 for ground to connect to the morimoto harness ballast plug using a male 9006 pigtail
I wired pins 3 power DRl 9006 pigtail to connect to Diodedynamics DS1 switchback driver
Did not use pin 5 drl power dim
Connected pin 12 power high beam and pin 14 ground to male 9006 pigtail. To connect to morimoto harness high beam plug.
For the turn signal I used a 7444 pigtail and connected to a 9006 male pigtail to connect to Diodedynamics DS1 switchback driver(Output used ground and yellow for turn signal and the white alone since headlight uses common ground for DRL). I first connected 7444 to 3157 to figure which two wires made turn signal flash since you do not use the other wire(used yellow and ground input).
I connected the 3157 directly to the switchback since this will connect to old turn signal bulb. Remember if it does not work rotate plug.
I ran a power wire from fuse 39 using a fuseblade to power switchbacks which in turn powered DRL
8 WIRE PIGTAIL MALE 9006 HB4 ONE HARNESS CERAMIC HEADLIGHT REPLACEMENT PLUG SOCKET
1 Small ACS-J Add A Circuit Piggy Back Pluggable Standard Blade Tap Fuse Holder
1 Morimoto MotoControl Bixenon: H13 9008 Harness TRS
2 Motorcraft WPT1357 Headlamp Connector
2 Diodedynamics DS1 switchback driver
2 Pre Wired Heavy Duty T20 Sockets Plugs Connectors Wiring Harness 7443 7444 992A
2 WIRE HALOGEN MINIATURE PIGTAIL MALE 3157 3457 TWO HARNESS REPLACE CABLE LAMP
Split tube wire wrap 3/8
Below are my finished products
turn signal with morimoto switchback drivers(old photo use Diodedynamics DS1 switchback driver wired )
turn signal bulb harness
9006 connectors connect to switchback and morimoto harness
16 pin connector