Mustang Evolution Forum banner

FS: HPM Megabite upper and lower CA's 99-04

1K views 9 replies 3 participants last post by  Sb98gt 
#1 ·
I have a set of HPM upper and lower control arms that i no longer need. These are like new, never installed. (one LCA has a few minor scratches from being in the garage) Includes all hardware, instructions, and spring spacers.

I would like to get $400 plus shipping for the set. These are the best control arms money can buy. They cost over $700 for the set new. I can email pics to serious buyers. Thanks!
 
#3 · (Edited)
They both fit '79-04. The lowers will fit '79-98 if you enlarge the control arm mounting bolt holes on the axle housing. Its a very easy modification to make. You just have to use a drill and make the hole a little bigger. Also i had a typo above, the uppers have been installed but never run. The bushings are good though and the lowers have never been installed. This is a steal
 
You have insufficient privileges to reply here.
Top