Mustang Evolution Forum banner

UCA Help

876 views 4 replies 3 participants last post by  steedamatt 
#1 ·
I picked up the steeda ADJ UCA for 60 bucks. Will i have to swap the mount or will i be fine using the stock one. Who has installed a UCA without upgrading the mount and do you have any noise
 
#2 ·
Have you talked to the Steeda support folks about the upper control arm requirements? I'd say they would be the best qualified in answering these good concerns you have.
 
#4 ·
Yah i just need the rear held down more i can feel it moving alot at high speeds and i know it will help my tire from not spinning at launch. my car is lowered to
 
#5 ·
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top