Well as you know the 01+ are different in more than one way.
99-00 lower intake
1) has two sensor holes on the lower
2) had NO intake valves
3) wire loom for plug wires is different (not big deal)
99-00 upper intake
1) vacume line on top is raised a bit but still same place
2) coil pack only has 3 bolts vs 01+ 4, may be an issue.... ideas?
99-00 heads
1) no sensors on the back of the head like 01+ has
01+ lower intake
1) only has one sensor the other is located on the driver side head
2) has intake valves and boxs that control the valves
01+ upper intake
1) has 4 bolts for coil pack
2) loom for plug wires
01+heads
1) has temp sensor in driver side head
sound like i ran run 99-00 intakes with 01+ heads and just cap off that spot on the lower?
or you think i ran run 99-00 heads and intakes? only issues is if the sensor in my head would work/fit in the lower intake.....
99-00 lower intake
1) has two sensor holes on the lower
2) had NO intake valves
3) wire loom for plug wires is different (not big deal)
99-00 upper intake
1) vacume line on top is raised a bit but still same place
2) coil pack only has 3 bolts vs 01+ 4, may be an issue.... ideas?
99-00 heads
1) no sensors on the back of the head like 01+ has
01+ lower intake
1) only has one sensor the other is located on the driver side head
2) has intake valves and boxs that control the valves
01+ upper intake
1) has 4 bolts for coil pack
2) loom for plug wires
01+heads
1) has temp sensor in driver side head
sound like i ran run 99-00 intakes with 01+ heads and just cap off that spot on the lower?
or you think i ran run 99-00 heads and intakes? only issues is if the sensor in my head would work/fit in the lower intake.....