ok so when i roll up my window all the way and shut my door the window gets caught on the top and the window wont seal but if i lower it a hair it will seal... why wont my window seal when my dads 99 conv does.... mine is a 98 conv.... and when it rains and my mom drives the car she cracks the window and she goes to roll it up she rolls it up all the way and then the driver seat is wet... what is causing this
You said you have to lower the window for it to act normal sealing wise? This sounds familiar, my buddies was doing the same rolling up too high, his window separated from the slider inside the door... Can't hurt to pull the door panel off and have a look before you buy anything
You said you have to lower the window for it to act normal sealing wise? This sounds familiar, my buddies was doing the same rolling up too high, his window separated from the slider inside the door... Can't hurt to pull the door panel off and have a look before you buy anything
You said you have to lower the window for it to act normal sealing wise? This sounds familiar, my buddies was doing the same rolling up too high, his window separated from the slider inside the door... Can't hurt to pull the door panel off and have a look before you buy anything
Looks to me like its out of alignment. If you take the foot panel off you can get to the track. My rear track does get out of place and needs adjusting over time. I'd start with that.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Mustang Evolution Forum
2.1M posts
50.9K members
Since 2003
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, horsepower, modifications, troubleshooting, racing, and more!