I picked up the steeda ADJ UCA for 60 bucks. Will i have to swap the mount or will i be fine using the stock one. Who has installed a UCA without upgrading the mount and do you have any noise
Have you talked to the Steeda support folks about the upper control arm requirements? I'd say they would be the best qualified in answering these good concerns you have.
You can use it with stock bracket, our bracket is far stronger then the factory one. You may get a slight increase in nvh due to the stiffer bushings but the performance trade off is worth it to most performance enthusiasts.
Yah i just need the rear held down more i can feel it moving alot at high speeds and i know it will help my tire from not spinning at launch. my car is lowered to
The lower control arms will eliminate the wheel hop. If your car is lowered and you have wheel spin problems the control arm relocation brackets will help correct the instant center of your car from being lowered and improve the weight transfer.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Mustang Evolution Forum
2.1M posts
50.9K members
Since 2003
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, horsepower, modifications, troubleshooting, racing, and more!