chin spoiler help?

[tedness]

got it and the grille delete from mustang tuning. and i wanted to know what size drill bit i should use to drill the holes for it if i use the included hardware? will post pics tomorrow before i go outta town once its on.

[Dom]

I don't remember what size I used for mine, but if your gonna do it by yourself pick up some of those plastic spring clamps. Those helped alot.

[tedness]

i'll see what i have tomorrow and figure it out. should i base it on the width of the screws or what?

[STEVE]

i dont knopw since ive never installed one, but just look at the screws it comes with and compare them to your drill bits.

[Dom]

Yea, and then slide the bit through the hole in the chin spoiler.

[Dark02Pony]

i think it was 1/4 inch that i used but dont hold me to that

[Dom]

Yea, I think it's a 1/4 too.

[SpectorV]

when in doubt go to small, i think its 1/8th or 1/4th i belive it comes with instructions and hard ware (or should) the key is get a friend to help hold it up, even it off side to side, dont just line it up on one side else the other will have a larger gap, you can pull it back off the front edge to line it up on the sides ( go all the way back ) or you can sacrifice a quarter inch perside~ and have it line up on the outer edge of the bumper (what i would do) just make SURE it doesnt stick out past the bumper....