Welcome to Mustang Evolution.
|
  |
|
|
|
06-27-2005, 05:56 PM
|
#1
|
|
  |
|
Got my bullitt petals on
|
|
WTF^^...
Join Date: May 2003
City: Hoover / Florence
State: Alabama
Posts: 27,361
Thanks: 0
Thanked 0 Times in 0 Posts
|
they came from rdmotorsport.com (97stallion) in record time. They were a BIOTCH to put on.... the dead petal was easy (just had to take the entire bracket off by removing the kick panel and side door jam panel to get to it) you can not just pry it off... to hard. I used a hammer to tap the new one in and it went fine. The accelerator petal also wasnt to bad.. the pin just tapped out with a little force and a vice to hold the assembly. The throttle cable was a little pita but not to bad.
here is the fun part... the brake and clutch petals... very very frustrating... they in NO WAY just slide over... it took forever and I thought I ripped the side of one, which you can do pretty easy. I finally worked them around... omg.... if you have a short fuze do NOT try this lol.
__________________
2003 REDFIRE COBRA #3938 of 5082 @ 05/27/2003 1 of 414
MGW Shifter, Stingers, JLT, SS Inserts, MM FLSFC & CC Plates, SS Lines, H&R Race springs, IRS Brace, MRT Hood Struts
ME.com Member #29 - 400rwhp/380rwtq
|
|
|
|
 
|
06-27-2005, 06:14 PM
|
#2
|
|
|
|
|
|
postarama
Join Date: Aug 2003
City: Southaven
State: Mississippi
Posts: 24,469
Thanks: 0
Thanked 0 Times in 0 Posts
|
Hm...dead pedal popped right off and back on for me. Brake pedal slid right on after I found the right tool, my problem was getting the pin out on the gas pedal, O well.
__________________
"I'm not driving too fast...just flying too low"
Mine:
-87 ranger- broke
-03 SB Cobra vert- 2552 of 5082 Born 02/25/03
Our's:
90 7up vert - new project
|
|
|
|
|
06-27-2005, 07:43 PM
|
#3
|
|
|
|
|
|
McLovin?
Join Date: Jun 2004
City: Atlanta/Chattanooga
State: Georgia
Posts: 3,734
Thanks: 0
Thanked 0 Times in 0 Posts
|
but i bet it was all worth it wasn't it Brandon 
oh and 
__________________
2000 White 3.8L 5speed with Custom True Dual Exhaust, K&N FIPK II air intake, Steeda Tri-ax, 2000 Cobra R's in 275/35/18 Summitomo's, Sequential Taillights...
also, 2001 ZX6R by Kawasaki
|
|
|
|
|
|
06-27-2005, 09:41 PM
|
#4
|
|
|
|
|
|
I liek gramer
Join Date: Jan 2004
City: Birmingham
State: Alabama
Posts: 19,169
Thanks: 0
Thanked 0 Times in 0 Posts
|
The dead pedal should have been much easier than that...
The brake pedal isn't so bad once you realize you have you whoop on it a minute and use something like a screwdriver to assist in the whoopage.
__________________
Delta Sigma Phi - building better men since 1899
|
|
|
|
|
|
06-28-2005, 05:31 PM
|
#5
|
|
|
|
|
|
WTF^^...
Join Date: May 2003
City: Hoover / Florence
State: Alabama
Posts: 27,361
Thanks: 0
Thanked 0 Times in 0 Posts
|
I realized why your petal was so easy to put on Brad.... cuz you have an auto...if i had the petal the size of my foot to put on it would have slide on rather easy also... try putting a clutch petal or even worse a brake... OMG
__________________
2003 REDFIRE COBRA #3938 of 5082 @ 05/27/2003 1 of 414
MGW Shifter, Stingers, JLT, SS Inserts, MM FLSFC & CC Plates, SS Lines, H&R Race springs, IRS Brace, MRT Hood Struts
ME.com Member #29 - 400rwhp/380rwtq
|
|
|
|
|
|
06-28-2005, 06:01 PM
|
#6
|
|
|
|
|
|
postarama
Join Date: Aug 2003
City: Southaven
State: Mississippi
Posts: 24,469
Thanks: 0
Thanked 0 Times in 0 Posts
|
I'm sure it goes on the with the same pain, I just found a tool that did it right.
__________________
"I'm not driving too fast...just flying too low"
Mine:
-87 ranger- broke
-03 SB Cobra vert- 2552 of 5082 Born 02/25/03
Our's:
90 7up vert - new project
|
|
|
|
|
|
06-28-2005, 07:02 PM
|
#7
|
|
|
|
|
|
sʞɔns ʇuǝɹq
Join Date: May 2003
City: Macon
State: Georgia
Posts: 10,777
Thanks: 0
Thanked 0 Times in 0 Posts
|
i bet i had the hardest time put my bullit pedal covers on!
__________________
-Jimmy I drive a station wagon.
GO BRAVES
|
|
|
|
|
|
06-28-2005, 07:15 PM
|
#8
|
|
|
|
|
|
WTF^^...
Join Date: May 2003
City: Hoover / Florence
State: Alabama
Posts: 27,361
Thanks: 0
Thanked 0 Times in 0 Posts
|
did you have the assembly out?
__________________
2003 REDFIRE COBRA #3938 of 5082 @ 05/27/2003 1 of 414
MGW Shifter, Stingers, JLT, SS Inserts, MM FLSFC & CC Plates, SS Lines, H&R Race springs, IRS Brace, MRT Hood Struts
ME.com Member #29 - 400rwhp/380rwtq
|
|
|
|
|
|
06-28-2005, 07:41 PM
|
#9
|
|
|
|
|
|
postarama
Join Date: Aug 2003
City: Southaven
State: Mississippi
Posts: 24,469
Thanks: 0
Thanked 0 Times in 0 Posts
|
He had to fab his own up if I remember right.
__________________
"I'm not driving too fast...just flying too low"
Mine:
-87 ranger- broke
-03 SB Cobra vert- 2552 of 5082 Born 02/25/03
Our's:
90 7up vert - new project
|
|
|
|
|
|
06-28-2005, 07:47 PM
|
#10
|
|
|
|
|
|
WTF^^...
Join Date: May 2003
City: Hoover / Florence
State: Alabama
Posts: 27,361
Thanks: 0
Thanked 0 Times in 0 Posts
|
all you got to do is JB weld the suckers on...
__________________
2003 REDFIRE COBRA #3938 of 5082 @ 05/27/2003 1 of 414
MGW Shifter, Stingers, JLT, SS Inserts, MM FLSFC & CC Plates, SS Lines, H&R Race springs, IRS Brace, MRT Hood Struts
ME.com Member #29 - 400rwhp/380rwtq
|
|
|
|
|
|
06-29-2005, 08:54 AM
|
#11
|
|
|
|
|
|
sʞɔns ʇuǝɹq
Join Date: May 2003
City: Macon
State: Georgia
Posts: 10,777
Thanks: 0
Thanked 0 Times in 0 Posts
|
yeah, i had to cut a ton of metal off my pedals to make them fit, plus modify the gas pedal since it came from a fox
__________________
-Jimmy I drive a station wagon.
GO BRAVES
|
|
|
|
|
|
