Clutch Problem! I think!!

[Scoot99V6Stang]

I have a Centerforce Dual Friciton clutch. Now 3 days after installing it my throwout bearing started singing again for me. Now after about 5 months, if I hold the clutch to the floor and rev it above around 2500 my car begins to lunge forward! Also, I just had my ranny rebuilt about 1500 miles ago. Now the problem is, it has a hard time going into gear. It like hits and then it will fall in. I sometimes have to SLAM it to ge into reverse or first to take off, once I take off it still shifts rough, but a little better! Now could all this be a clutch cable problem. Maybe the clutch pedal isn't completely engaging or disengaging the clutch? Should I start out by getting an adjustable clutch cable to see if that will fix it? IDK what to do, I'm hoping that is the problem, especially with the freshly rebuilt tranny still giving me problems, before the tranny was rebuilt I was having the same problems. Could it be the clutch or clutch cable? Thanks guys. Any ideas would be greatly appreciated!!!

[jedwards242000]

what did you torque the pressure plate bolts to

[Scoot99V6Stang]

We used the German torque method of Gudentite! I have no idea. LOL

[Scoot99V6Stang]

bump

[SpectorV]

they have to be correct to much or to little can cause problems. You cant do mods like this or motor work without doing it right. The flywheel may have nothing to do with it either. just one of those try and see... and hope you get it right.

[jedwards242000]

well i did that the first time i installed my clutch and i had the same problem you are having. i took the trans back out and everything looked ok, so i torqued the pressure plate bolts down to proper spec and everything is working great now, i love the clutch. also while you have the trans out go ahead and replace the pilot bearing and throwout bearing while your in there if you already havent.