Drivers door controls broken...what do I need to repair?

MF-DIF · 08:03 PM

I'll let the pictures do the talking....00 Mustang V6.

As you can see the controls slumped into the door card bezel. I popped it off and noticed the plastic was just glued on to the bezel from the factory, and had snapped. I tried to use some automotive plastic adhesive, but it only held it a day. What parts do I need to place...and where is the best place to order. It doesnt look like there where ever clips holding it in, just plastic to plastic glued.

**Brent** · 08-04-2006, 08:02 PM

Super Glue no worky?

MF-DIF · 08-04-2006, 08:07 PM

Super glue no worky.

tedness · 08-04-2006, 08:14 PM

i can't remember if the switch and panel is one piece when buying a replacement or not...

**bbunt302** · 08-04-2006, 08:16 PM

When you tried to glue it on did you clean off all the old glue? You'll have to get all the old glue off and get a clean surface (wipe it down with alcohol) before it will ever stick.

MF-DIF · 09:59 PM

Yup cleaned it off with alch, and let it cure a day as well. Are there any online vendors that have the full oem catalog of parts I can order from?

lowflyn · 08-05-2006, 08:29 AM

If you were any closer I would tell you to send it by here. I have some stuff that will hold it

WhiteStang99 · 08-06-2006, 02:59 AM

there is a screw at the top and bottom of that piece that are supposed to hold that in.

MF-DIF · 08-06-2006, 08:49 AM

Hmm...I don't see any place where a screw was tapped to the bottom of the bezel. It is completely smooth. There are holes on the switch box, but those where filled with a plastic nipple and glue from the bezel.

So no OEM vendors guys? Just dealers huh.

WhiteStang99 · 08-06-2006, 01:20 PM

yeah, now that i think about it, the screws just hold the buttons in that little thing that should stay attached to the bezel. Sorry bout that.