289poweredJag

Join Our Mustang Forums Today! Click Here To Register!

Advertisements

Support Our Sponsors!

Atomic Performance	American Muscle	StangSuspension.com	StangShifters.com
THR Mustang Parts	Total Performance Solutions	Advertise Here!

Welcome to Mustang Evolution.

		Mustang Evolution > Mustang Forums > Regional Mustang Forums
289poweredJag

Reply

Old

12-24-2007, 10:10 AM

#1

289poweredJag

289poweredJag Registered User Join Date: Dec 2007 City: Sacramento State: California Posts: 2	Is there a special tool to align the hexaginal long shaft that comes up from the engin to slip into the opening at the bottom of the distributor shaft? At one point while I was tring to install a PerTronix distributor, the long shaft stayed verticle. However, it now seems to lean to the side of the opening thus preventing installation.

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
289poweredJag	289poweredJag	Regional Mustang Forums	0	12-23-2007 11:34 PM