I'm installing these myself.. I already have the seats and body panels out.. But the directions are confusing as hell. Someone help me out. Please.
Materials:
10/64 bolts (6)
¾ Double Side Tape
Adhesion Promoter
Rubberized Undercoating
Where the hell can I find 10/64" (5/32) allen head bolts? I've been to like 3 hardware stores and the smallest they carry is 5/16". And those weren't even allen head. They were hex head. Where can I get these? Or, alternatively, what else can I use?
The same goes with the 3M 3/4" Tape.. Haven't found it at any hardware or auto store.. It's either 1/2" or 1"... And I think they rate the tape based on stickyness.. What should I use?
The adhesion promoter... I found that. But it says it's for paint adhesion.. Since I'm not painting anything.. What good is that?
Here are the directions I'm confused with:
Step 1: Clean area with prep-solvent
Step 2 : Mask area and under coat
Step 3: Clean tape area of paint and primer residue with lacquer thinner
Step 4: Clean area again with prep-solvent
Step 5: Apply a coat of adhesive promoter
Step 6: Apply double side tape to cleaned area
Okay.. So I prep... Mask the painted areas... Undercoat the unmasked area.. Then I use lacquer thinner on the undercoat? That makes no sense... Then I put down a coat of adhesive promoter and then put tape on top of that? Huh? This really needs pictures.
Somebody help. I know someone here knows wtf he's talking about.
you must have bought these things from Saleen to get all of that stuff, I didnt use/have any of the mentioned items. We had boughten ours off of Ebay and had them painted from a local body shop and then we eventually installed them. What I had done was peeled off that plastic covering that was under the V6 Scoop from factory and painted that part black, and then took some 3M Scotch tape and put it back in place, and then just applied the scoops in place and peeled back the 3M doublesided tape and then tightened them up and away it went!
