Mustang Evolution Forum banner

Spark issues

1K views 5 replies 5 participants last post by  scottydsntknow 
#1 ·
I was installing MSD's two step onto my car and I have wired the clutch wire in and that works all right but when I start the car, it is like I have no spark. The starter spins but nothing happens. Anybody have any ideas. I plan to test voltage on each coil but I can see them all just shorting out and going bad
 
#2 ·
Not sure what exactly is going on, but if the engine was working correctly before the installation, there is obviously a problem with either the MSD box, or the install was done incorrectly. I
I would remove everything associated with the MSD and see if the engine will start.
 
#6 ·
Agreed with Stray, its either an issue with the Might Suddenly Die (MSD) product or you messed up the install.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top