Mustang Evolution - Search Results

Go Back   Mustang Evolution > Search Forums



Showing results 1 to 20 of 193
Search took 0.49 seconds.
Search: Posts Made By: Haav2
Forum: 1979-1995 Mustang GT 09-17-2018, 11:42 PM
Replies: 10
Views: 871
Posted By Haav2
thats what i was suspecting even though i...

thats what i was suspecting even though i replaced my fuel filter i guess its worth a check. I've been hearing about a fuel pump or fuel pressure check valve online and maybe it could be bad, i just...
Forum: 1979-1995 Mustang GT 09-17-2018, 11:40 PM
Replies: 10
Views: 871
Posted By Haav2
I installed one last week but its in the engine...

I installed one last week but its in the engine bay. it read 60psi when first installed it.
keep in mind the problem was still there with 60psi, i just installed it to see where i was at in fuel...
Forum: 1979-1995 Mustang GT 09-17-2018, 11:34 PM
Replies: 10
Views: 871
Posted By Haav2
It ran fine, lots of power! just until a month...

It ran fine, lots of power! just until a month and a half ago this started happening. I only drive the car on the weekends and less now because of this problem.
Forum: 1979-1995 Mustang GT 09-16-2018, 12:52 PM
Replies: 10
Views: 871
Posted By Haav2
Boosted Car popping and stumbling when accelerating

As of late my 89 fox supercharged hesitates and pops when i accelerate HARD, somewhere around 3500rpm and up. doesn't do it in low rpm accelerations.
I'm at 6lbs of boost and fuel pressure at...
Forum: 1979-1995 Mustang GT 09-16-2018, 12:45 PM
Replies: 6
Views: 783
Posted By Haav2
just installed the oem cable, thanks for the...

just installed the oem cable, thanks for the advice!
Forum: 1979-1995 Mustang GT 09-04-2018, 09:26 PM
Replies: 6
Views: 783
Posted By Haav2
thanks! I installed a new adjustable clutch cable...

thanks! I installed a new adjustable clutch cable and quadrant with 3 hooks on it. the cars clutch pedal feels a lot better than before!!
Forum: 1979-1995 Mustang GT 08-25-2018, 04:46 PM
Replies: 6
Views: 783
Posted By Haav2
Clutch pedal goes all the way down, no tension at all

Today while driving around in my 89 foxbody 5spd as I pressed down on my clutch pedal I heard a snap sound and my clutch pedal went all the way down. It doesn’t come back up either. I’m guessing my...
Forum: 1979-1995 Mustang GT 07-08-2018, 01:24 PM
Replies: 4
Views: 552
Posted By Haav2
yeah, ill definitely get the intercooler first,...

yeah, ill definitely get the intercooler first, would the bypass/bov have to be relocated once the ic is installed?
Forum: 1979-1995 Mustang GT 06-21-2018, 03:15 PM
Replies: 9
Views: 1,345
Posted By Haav2
Yeah, lol I thought I could give it a try as I’ve...

Yeah, lol I thought I could give it a try as I’ve worked on everything else on this car.
Forum: 1979-1995 Mustang GT 06-16-2018, 11:04 PM
Replies: 9
Views: 1,345
Posted By Haav2
3.73 gear install disaster.

Installed 3.73 gears today on my fox. I think I should have taken it to a diff shop because my diff feels too tight now. It’s hard to turn the rear wheels by hand at the moment. I let the car run in...
Forum: 1979-1995 Mustang GT 06-09-2018, 11:01 AM
Replies: 4
Views: 552
Posted By Haav2
Upgrade vortech v3

I’m trying to see how I can up the boost on my vortech v3 sci. I want to make 10 to 12lbs of boost, I’m currently running 6lbs max at wot around 4500 to 6000rpm. I’ve heard of pulley changes but...
Forum: 1979-1995 Mustang GT 06-07-2018, 06:43 AM
Replies: 2
Views: 502
Posted By Haav2
Id go with 3.73s but since youre at 3.55 already...

Id go with 3.73s but since youre at 3.55 already you wont feel too much of a difference compared to getting the 4.10 gears. But with 4.10s, your gas mileage will be worse im sure you already know...
Forum: 1979-1995 Mustang GT 05-20-2018, 08:40 PM
Replies: 1
Views: 984
Posted By Haav2
Anyone have experience with microsquirt/megasquirt?

trying to see if any fox guys are running microsquirt/megasquirt ecu.
I just got mine and am getting the hang of it, just got the car to idle somewhat decently.its just when i go around the block,...
Forum: 1979-1995 Mustang GT 05-20-2018, 08:31 PM
Replies: 2
Views: 787
Posted By Haav2
yeah, one of the notches were 0 degrees and 10...

yeah, one of the notches were 0 degrees and 10 degrees btdc. i got a piece of msd timing tape and got it on there where it needs to go. it was a cheap balancer but ill be replacing very soon.
Forum: 1979-1995 Mustang GT 05-17-2018, 10:00 AM
Replies: 2
Views: 787
Posted By Haav2
Harmonic balancer has no timing marks how do I find “0”?

I wan to set my base timing to 10 degrees tdc with a timing light but my balancer doesn’t have any numbers, just two notches. Are one of these notches 0 degrees? I have a doorman balancer from...
Forum: 1979-1995 Mustang GT 05-12-2018, 09:42 PM
Replies: 3
Views: 971
Posted By Haav2
Yeah I know, can’t do too much with a stock...

Yeah I know, can’t do too much with a stock block. I’m still looking into getting a coyote, and keeping my fox as well. I’ll just have too wait for my credit to go up like 20 more points and I’ll be...
Forum: 1979-1995 Mustang GT 05-06-2018, 09:46 AM
Replies: 3
Views: 971
Posted By Haav2
Ready for some more mods!

Throughout the years my 89 fox has been great to me, but there was once a time a few months ago where i was starting to consider getting into a more modern stang (2011-2014 5.0 ) to start another...
Forum: 1979-1995 Mustang GT 10-16-2017, 10:26 PM
Replies: 4
Views: 966
Posted By Haav2
I was looking to see why my car would shut off...

I was looking to see why my car would shut off after diving for a few miles, thought it was something with the tps, I applied 12v with a power probe to the red wire of the tps and the car shut off....
Forum: 1979-1995 Mustang GT 10-08-2017, 07:06 PM
Replies: 4
Views: 966
Posted By Haav2
My computer was infact fried. i bought one this...

My computer was infact fried. i bought one this afternoon for $169 at napa. only difference was that my old computer said: e9zf-12a650-a2a. new ecu ends in aa instead of a2a. it all works, only...
Forum: 1979-1995 Mustang GT 10-07-2017, 05:57 PM
Replies: 4
Views: 966
Posted By Haav2
Need help! Ecu might be fried!

I’m in need of help here. Today as I was looking to find my idle surging/ random shut off issue, I applied 12v with a power probe to the red or orange wire from the tps sensor and the car shut off....
Showing results 1 to 20 of 193

 
» Premium Vendor
» Like Us On Facebook



04:04 AM


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.

MustangEvolution.com is in no way associated with or endorsed by Ford Motor Company.