Mustang Evolution Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,627 Posts
Discussion Starter #1
Quick description of my ride:
07 gt
Manual w 3:55 gears
Hooker ceramic coated longtubes
Bassani off road x (but I have it up for sale about to slap a jba off road h)
cmdp
Jlt Gen 1
Gt500 Tb (still need adapter plate)
Borla stingers
Steeda short throw
adj uca
Adj panhard
Frpp k springs

I'm looking to pick up rear lca, and possibly slicks and skinnies off cl before I make my first run down the quarter in this car... I plan on going to tx motor speed way by Dallas the track is damn sticky for the most part

I'm not too sure how to prep the slicks b4 a run... I've never ran w em... so I have a few questions:

1: how much of a burn out is needed

2: burnout n water box right?

3: what is a safe rpm to launch from (dd and I do a **** ton of driving can not afford to break )

4: will I bog down launching at 3 grand to stay on the safe side?

5: and do any of you have similar mods on a 05-09 that has ran w slicks? What kinda time should I be shooting for?
 

·
Registered
Joined
·
2,789 Posts
With drag radials go around the water box and reverse into it, do a good burnout and launch at 3000-3600

---------- Post added at 10:01 PM ---------- Previous post was at 09:59 PM ----------

Depending on the conditions you should get a 12.8ish and avg low low 13s
 

·
Registered
Joined
·
1,627 Posts
Discussion Starter #3
I'm not using radials it will b a true mt slick if I do it... I'm not going to be happy unless I hit mid 12s , if I don't I'm selling it and getting back into the fox bodies: -)
 
1 - 3 of 3 Posts
Top