Mustang Evolution Forum banner
1 - 10 of 10 Posts

· I liek gramer
Joined
·
18,844 Posts
Discussion Starter · #1 ·
Alright, I bought a 2-way alarm off of ebay. The same alarm is for sale here: Alarmacar.net There is very little that this alarm does NOT do...

I get the alarm for much cheaper than it is sold on that page, so I'm excited. Then I get it. It's in a box with GV9 proudly stamped on the top. Apparently I got a no-name brand alarm, but I'm not too surprised by that.

So I open it and look at the instructions. They ARE in English, but only barely. Example: "Never throw heavily you are remote. or to dip into water or expose to heat extreme. We is not responsible for the hitch caused in operation of the unit by these problem." Word for word. But at least it does have a wiring diagram.

I call around, go to some alarm, audio shops here in town, only one guy in my whole city will do it, for $200. This may not be bad for the alarm I'm getting, but I don't have the money, and being the impatient lil sumbitch I am, I want the alarm on now.. heh.

My friend wanted to look at it, so I took it to his house, and he hooked the whole damn thing up in his living room, using some PC power cable as the power, and he got it all working, without being on the car, of course. So I'm inclined to believe he knows what he's doing. He also installed his remote start on his Del Sol, which I do know is an import and different from our cars.

Now, the question. Do I let my friend install it for the price of a large pizza, or take it to the professionals when I have $200?

Thanks for reading my huge post and for your input guys.
 

· I liek gramer
Joined
·
18,844 Posts
Discussion Starter · #5 ·
Any more suggestions? I'm still pretty undecided on the matter, but leaning toward letting my friend do it.

Anybody know if I would need an alarm bypass or anything else special? I do have Ford remote doors, trunk, and panic.
 

· I liek gramer
Joined
·
18,844 Posts
Discussion Starter · #7 ·
alright, thanks man. Do you think you could send me that diagram/sheet, just in case? I'm still undecided about it. If we do install it ourselves, itll be sometime next week tho.
Thanks for the help. I'm tellin my friend if he messes it up, he can pay to have it done. So if he's confident enough for that, I'll probably let him do it.
 

· I liek gramer
Joined
·
18,844 Posts
Discussion Starter · #13 ·
Laser02 said:
My dad (99 v6) had PATS.

well thats all i needed to know. I found some DEI 555Fs on ebay, for around 30 if i remember right. Now my friend wants me to pay him, or mentioned it at least, so if I'm going to end up paying a good bit for this, ill just save a few extra bucks and get it done profesionally. Thanks for yalls help. :)
 

· I liek gramer
Joined
·
18,844 Posts
Discussion Starter · #19 ·
OK, so anybody have a wiring diagram I could use or a place I might can find one?

It's been a while, and I still haven't gotten one from x77911. I am going to let my friend do it, and he'll charge me a lot less if I can get a diagram...
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top