Mustang Evolution Forum banner

1 - 20 of 22 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter #1
R the stock split intake heads and manifolds the best or are there aftermarket ones that are better?
 

·
Registered
Joined
·
1,694 Posts
Hit up Kyle he does good work, pretty good prices too

http://kylepersonperformance.m.webs.com

I'm guessing manifolds refers to exhaust?
Pacesetter makes a good set of long tube headers for $200, check out eBay
 

·
Registered
Joined
·
1,694 Posts
Talk to TMA, good turbo kits, or look for used ones floating around
 

·
Registered
Joined
·
1,694 Posts
Completely done hot and cold sides, that's why its almost 4K lol
 

·
Registered
Joined
·
1,694 Posts

·
Registered
Joined
·
1,694 Posts
The same car that made 800+rwhp only used a single turbo as an example, all it takes is a properly done single setup to make good power
 

·
Registered
Joined
·
1,694 Posts
Will porting and polishing a stock m/p intake be my biggest bang? Or buying an aftermarket?
Lower intake yes, Windstar upper intake does better than ours though
 

·
Registered
Joined
·
1,694 Posts
96-98
 

·
Registered
Joined
·
835 Posts
windstar intake, and the headers off of a 1994-98 3.8 mustang.
They came with short-tube headers from the factory and there as good as the after market shorties. You can just P&P your lower intake and heads.
 

·
Registered
Joined
·
1,694 Posts
if you do it yourself be very careful to not mess up the air velocity otherwise you'll lose power
 
1 - 20 of 22 Posts
Top