Mustang Evolution Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
141 Posts
Discussion Starter #1
Well I took my block in today to get machined and found out that it is aluminum. It totally doesn't look like it. So I don't know if they are all like that or not.
 

·
Registered
Joined
·
3,783 Posts
Claypops said:
Ok well I'm replacing those anyways. What's stronger? The iron block or aluminum?
Iron, but it weighs to much for a mustang. I think the alum motors make the nose weight 51%, anything more is not gona be the safest car out there.
 

·
Registered
Joined
·
141 Posts
Discussion Starter #8
Since they are already sleeved, when it gets board 20 over does it need to be sleeved again? I know nothing about that
 

·
Registered
Joined
·
3,783 Posts
Claypops said:
Since they are already sleeved, when it gets board 20 over does it need to be sleeved again? I know nothing about that
You'll be fine

---------- Post added at 05:57 AM ---------- Previous post was at 05:56 AM ----------

Unless you have major damage
 
1 - 10 of 10 Posts
Top