Mustang Evolution Forum banner
1 - 2 of 2 Posts

· Registered
46 Posts
Discussion Starter · #1 ·
I am swapping a 1990 AOD into a 1970 Mustang and I am almost done, but it looks like the slip yoke and the drive shaft need different sizes of U-joints. Is there some kind of u-joint with different sizes that I could use to combine the two, and if so, does anyone know how I can find the dimensions I need?
Thanks in advanced.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.