Mustang Evolution Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7,140 Posts
did you have the rotors machined when the new pads were installed? and i know you said you lubed the slide pins but did you also lube where the pads sit in the hardware?
 

·
Registered
Joined
·
7,140 Posts
yeah unless you're just wanting them for looks unidirectionals will be just fine...and machinable
 

·
Registered
Joined
·
7,140 Posts
easy swap at least...but if the pads are making the rotors wear uneven then it'll be an issue that'll start to follow the rotors
 
1 - 4 of 4 Posts
Top