Mustang Evolution Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
497 Posts
Discussion Starter · #1 ·
So I built this a little while ago for my previous car, not sure if it will fit in the GT yet. We will see about it this weekend though! Tell me what you guys think!
 

Attachments

·
Registered
Joined
·
497 Posts
Discussion Starter · #3 ·
Close. Measure it. How's u do the carbon fiber?
I measured it today, it will not fit either getting inside or for say if I did get it inside it still would not fit right. and for the carbon fiber, I made my mdf box routes out my holes for the subs, then laid my carbon fiber on the face of the box wet and then rolled it out numerous times with epoxy. then built it up, block sanded it, then wet sanded it. finally cleared it with some ppg shopline clear. once it gassed out I went over it with 3000 on the da and used 3M's compounds 1,2 and 3. and you'll end up with that :)
 
1 - 3 of 3 Posts
Top