Mustang Evolution Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
Im getting a good deal on a cobra upper and lower so just wanted to make sure my plans will work. I planning on a 70mm tb, 24# injectors and port the intake as well. Any suggestions (car is a daily driver with no serious mods) thanks
 

·
Registered
Joined
·
493 Posts
Also: you will need a MAF calibrated to your injectors. Try to pick up one that is at least 5mm bigger than your tb to create a "funnel" effect. :good
 

·
Registered
Joined
·
672 Posts
In all honesty you won't see any difference in the setup without upgrading to MAF. Your car will probably run worse. Speed density uses a preset table to determine A/F ratio and doesn't take advantage of any increase in intake air. Definitely get a MAF setup. You'd probably see a 20-30 rwhp increase with the new intake, tb, and MAF.
 
1 - 13 of 13 Posts
Top