Mustang Evolution Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hey guys, just bought some brand new LED Halo projector headlights for my 06 mustang. Before installing I sealed them, or so I thought. Noticed some condensation or a foggy patch in the bottom corner...How can I get rid of that and better prevent it from happening again?

Help! Picture below.

image-1757814326.jpg
 

·
Registered
Joined
·
1,014 Posts
Seal it better. It has to be getting in there somewhere. Maybe u just missed a little spot, that's all it takes. Good luck.
 

·
Registered
Joined
·
350 Posts
Put some silicone around them and make sure the bulbs are tight against the housing.
 

·
Premium Member
Joined
·
26,052 Posts
sometimes you have to reseal them especially if they are aftermarket, not sure what stuff people use (silicon perhaps will do it)
 

·
Registered
Joined
·
137 Posts
Same thing happened to mine. It's most like the bulb/housing part that's allowing moisture in.
 

·
Registered
Joined
·
74 Posts
moisture in head lights

I had the same problem with my custom headlights. Pulled the plastic lens covers off (make sure you get ALL of the old sealant off). I used windshield sealant to reseal the lens covers. This stuff when setting up actually seeks out gaps. Haven't had any problems since.
 
1 - 11 of 11 Posts
Top