Mustang Evolution Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,608 Posts
Discussion Starter #1
Am thinking about getting a gt500 axelback but i am also getting a SW long tube header O/R xpipe and it is 3 inch and the tube for the acelback is 2.75 i believe, so how do i connect them two??
 

·
Registered
Joined
·
1,791 Posts
You will have no issues using the factory midpipes and connections. Everything will hook up with no problem.
 

·
Registered
Joined
·
1,608 Posts
Discussion Starter #3
DWC_SmOziLLa said:
You will have no issues using the factory midpipes and connections. Everything will hook up with no problem.
So where do i get the connection from the 3 inch pipe to the 2.75 pipe???
 

·
Registered
Joined
·
3,045 Posts
So where do i get the connection from the 3 inch pipe to the 2.75 pipe???
It's already on your car. There are multiple pieces of the exhaust system in the S197 Mustang platform. From engine to rear bumper they are:

  • Headers/Manifold
  • Catalytic Converters
  • H-Pipe
  • Over-axle Pipes
  • Mufflers/Axle-backs
The mods you listed do not replace the over-axle pipes, which connect the cats/h-pipe (or offroad midpipe) to the mufflers/axle-backs.
 
1 - 4 of 4 Posts
Top