Mustang Evolution Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
861 Posts
Discussion Starter · #1 ·
So I decided to to take care of some maintenance that I have been putting off namely new coolant temp sensor, and new 23 tooth speedo cable gear. In a day or two I was planning on doing a MAF conversion which is en Route via Fiveology and LRS. Well I was worried about coolant getting out of the threads from the temp sense because my Haynes manual said to "Put electrically conductive sealant on the sensor" I was confused to say the least. Long story short, I over tightened the sensor and cracked my stock intake (lower). Any Ideas were to get a new intake?? I am on a tight budget :uhh:
 

·
Registered
Joined
·
143 Posts
What year mustang and what size engine?? I bought a lower stock intake for my 91 GT and ended up not needing it. I still have it wrapped in cardboard. I bought it used as is. I live in northern Ky. My email address is [email protected]
 

·
Registered
Joined
·
1,563 Posts
eBay
 
1 - 6 of 6 Posts
Top