Mustang Evolution Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1
I found a man selling these cams. Would I need to re-spring my heads for these? Stock PI's now.
 

·
Registered
Joined
·
1,013 Posts
Slow2V said:
Springs/retainers you will need with any aftermarket cams besides Anderson cams
Not necessarily true depends on the mildness of the cam some work on stock springs. I would look up the part numbee and see if they would work without respringing....however slow is right its best recommend to upgrade springs to prevent premature failure of the springs.
 

·
Registered
Joined
·
116 Posts
Discussion Starter #4
Ok. The cams are 268 intake and 272 exhaust. Doubt they have the cam card.
Would this make them stage 2's?

Says they have approx. 2000 miles on them and asking 350 with the cam gears still attached.
 

·
Registered
Joined
·
1,013 Posts
I say go on the crower website and check out their specs
 

·
Registered
Joined
·
1,013 Posts
Ill see if i can find the link then ill post ot here
 
1 - 8 of 8 Posts
Top