Mustang Evolution Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Dart Blocks, who has one, and how "finish machined&quot

I am seriously considering a 351-W Dart block, but am curious how much machining it will need, especially compared to a 4-bolt Motorsport block. If you have one, or have experience with them, lets hear what your opinions are...
 

·
Registered
Joined
·
251 Posts
The Dart block can be purchased in a 100% ready to build state. Warning though it isnt cheap!! $2900 is the best I can get them for.
 

·
Registered
Joined
·
12 Posts
Discussion Starter #7

·
Registered
Joined
·
12 Posts
Discussion Starter #8
Jayber said:
The Dart block can be purchased in a 100% ready to build state. Warning though it isnt cheap!! $2900 is the best I can get them for.
I can get them 2K delivered, but I wanted to see if they needed additional machine work, or not.

I was eyeing the aluminum block, but the Iron will do just fine. It will take a bigger over-bore:)
 

·
Registered
Joined
·
941 Posts
Jayber said:
The Dart block can be purchased in a 100% ready to build state. Warning though it isnt cheap!! $2900 is the best I can get them for.
same here... except if you wait around and find an aborted project you can snatch one up for about 2,000-2,400, usually brand new.

dart blocks are the only way to do it right!
 
1 - 9 of 9 Posts
Top