Mustang Evolution Forum banner
1 - 16 of 16 Posts

·
Registered
Joined
·
2,401 Posts
Discussion Starter · #1 ·
AM just started selling aluminum one piece driveshafts for the 05-10 v6, auto only though!!!!!!!
 

·
Registered
Joined
·
523 Posts
How did you manage to do that?? And what's 'gov'?
The governor. I looked into it and you can take them off with a tune. If you have the horsepower your car can go faster than 120. But you need an upgraded driveshaft to go above that or it'll be ripped apart because of the 2 pieces the stock has
 

·
Registered
Joined
·
523 Posts
How did you manage to do that?? And what's 'gov'?
The governor- makes sure your car doesn't exceed the speed your tires are meant for. So with upgraded tires and a one piece drive shaft, both of these can be taken off from the ECU with a tune! Although all of this is very expensive I say it'll definitely make your v6 track worthy
 

·
Registered
Joined
·
42 Posts
I seen the driveshaft also and was wondering if it would cost as much or more to have one built? Is installation a DIY project with basic tools for a novice mechanic? Thanks guys
 

·
Registered
Joined
·
488 Posts
Yeah I watched the guys at my shop install it on my car an Im pretty good at just about anything when it comes to the v6 but messin with the driveshaft isn't something I'd recommend doing by ur self
 

·
Registered
Joined
·
2,401 Posts
Discussion Starter · #16 ·
Yeah I watched the guys at my shop install it on my car an Im pretty good at just about anything when it comes to the v6 but messin with the driveshaft isn't something I'd recommend doing by ur self
Yeah there's no room for error there
 
1 - 16 of 16 Posts
Top