Mustang Evolution Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Can someone please tell me, based on these photos, if I have the front crankshaft oil seal installed properly? I tapped it into place with a rubber mallet, and the outside edge is even with the outside edge of the hole for the crank (meaning, even with the edge of the hole, on the outside of the engine front cover). I'm unsure as to whether it's supposed to be seated deeper into that hole, or not. Thanks!

This is a 2002 Mustang GT SOHC (2-valve) V-8.

P1020512.jpg
P1020525.jpg
 
1 - 3 of 3 Posts
Top