Mustang Evolution Forum banner
1 - 9 of 9 Posts

·
Registered
2014 Shelby GT500, SGM, " 1 of 1 "
Joined
·
894 Posts
If you just cut a hole, the extractor won't sit flush. It's between 0.130 & 0.150 thick, so a recesssed lip would have to be formed in the hood for it to mount. There is a lip cast into the front edge of the extractor & ( 1 ) small screw with 2 small locking clips in the rear. Double sided tape is used on the rear edge. Would expect a body shop to charge you a good buck to do this work. ( the extractor is curved, may or may not be the same curve as your hood )
 

·
Registered
Joined
·
1,791 Posts
1 - 9 of 9 Posts
Top