Its a 2.3 L Ford Engine, 1985 Mustang, no turbo. The problem is that I have an oil leak there. Do i have to put some kind of sealant? Or a gasket? The top it is connected to the PCV valve hose and the bottom to the engine block, and thats where it leaks oil, to take it out i just pulled it effortlessly, it had no gasket or sealant. it just sat there. Anyone familiar with this type of Oil Separator?
How do I install an Oil Separator?
1 - 2 of 2 Posts
a push-in separator! very common, leaks usually occur because the motor is dead/dying and the crankcase is pressurized with blowby. Re-ring or rebore time.
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Join the discussion
Mustang Evolution Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, horsepower, modifications, troubleshooting, racing, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!