Mustang Evolution Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
The only problem is they welded them where the old ones were. I got longer tips for a reason and they still put them in the same place :oops:
If I take them back to the shop is it gonna cost me anything to get them rewelded?
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
And I also found out that the shop before this put on 2.5 tailpiping when I ask for 2.25. I'm having bad luck with muffler shops :(
 

·
Registered
Joined
·
10 Posts
Discussion Starter #6
Guess I'll just have the shop do it when I replace my mufflers to spintechs cuz I messed up and got delta 40's.

Damn I'm learning lessons hard :(
 

·
Registered
Joined
·
10 Posts
Discussion Starter #7
They said they can't reweld them because my 18" tips werent long enough :-?
They said GT's had 40 inch tips :-?
 

·
Premium Member
Joined
·
5,187 Posts
Yes the tips on the GT are long. How far do they stick out. If they are stainless you could cut them. If they are chrome you are stuck unless you get new tips. as far as the size of pipes are you going to do any engine mods like P&P heads, intakes and cam because if you are just leave the tailpipes alone. Even 2.5 is large for stock 3.8 motors you are really not going to notice much if any loss.
 
1 - 8 of 8 Posts
Top